Images May Not be Vehicle Specific. For Display Purposes Only.

PHR Cam & Crank Hall Effect Sensor Kit

Select a Vehicle to See Parts for Your Car

Fitments

Select A Make to Narrow the Selection
TOYOTA UNIVERSAL

Product Description

The PHR Cam and Crank Hall Effect sensor is designed for builders and tuners needing a more stable and/or reliable sensor for motor speed and sync. A lot of ECU’s can use these sensors for getting a cleaner and more consistent reading. This leads to faster starts, fewer tigger faults, more accurate ignition timing as well as several other benefits.

The benefits of using Hall Effect Sensors over VR (Magnetic) sensors is a long list:
Resistance to Electro Magnetic Interference (EMI)
Very little or no filtering required
No minimum engine speed to produce a minimum trigger voltage. Important with a slow cranking motor especially with low battery voltage
Triggers precisely on trigger edge and not on trigger voltage threshold position in VR’s waveform (which can vary with motor speed)
Easy Cam and Crank Syncing
Precise Ignition Timing
No Ignition Timing Float
Immune to Target Runout
Rotational Alignment to target is not critical
High Speed Operation (up to 15khz)

Features:
Direct bolt-on
Brackets made from Billet Aluminum
Uses DTM Connectors and Terminals
Large Operating Temperature Range
Works with all aftermarket ECU’s.
Uses Stock Trigger Wheel and Cam teeth
Made in the USA

The PHR Cam and Crank Sensor Kit is known to work with the 2JZ 12 tooth crankshaft trigger wheel and has not yet been tested on 2JZ VVT-i 36-2 trigger wheels or 3 tooth VVT-i Cam teeth.